![]() My exact location is Loughton, Essex, UK. ![]() I also live (geographically) in a high area. My antenna is attached to the external chimney on top of the property (this is the highest point in the property). Yes, my digital TV is able to pickup all UK Freeview channels without any tell us more about antenna setup please post a photo of this antenna and your exact location where you live at based on this photo it looks like you're get ghosting signal often caused when a TV signal travels by two different paths to a receiving antenna, with a slight difference in timing. So my signal would be PAL and T2.ĭoes your antenna setup and this card work elsewhere? My nearest transmitter is Crystal Palace. em28xx 1-3:1.0: Remote control support is not available for this live in the UK just outside north-east London. em28xx 1-3:1.0: reading from i2c device at 0xa0 failed (error=-5) em28xx: Registered (Em28xx Input Extension) extension Philips LTE Filter for TV Antenna, Filters 4G 5G LTE Signal to Reduce Interference and Pixilation for Clear Digital HD TV Reception, Frequency Range 5-608 MHz, Indoor Outdoor Installation, SDW1520/27. em28xx 1-3:1.0: Remote control support is not available for this card. This item: Hauppauge 1657 WinTV-DualHD Dual USB 2.0 HD TV Tuner for Windows. em28xx 1-3:1.0: Input extension successfully initialized rc rc0: lirc_dev: driver em28xx registered at minor = 0, scancode receiver, no transmitter em28xx 1-3:1.0: Registering input extension em28xx: Registered (Em28xx dvb Extension) extension em28xx 1-3:1.0: DVB: registering adapter 1 frontend 0 (Silicon Labs Si2168). em28xx 1-3:1.0: DVB extension successfully initialized em28xx 1-3:1.0: DVB: registering adapter 0 frontend 0 (Silicon Labs Si2168). usbcore: registered new interface driver em28xx em28xx 1-3:1.0: dvb ts2 set to bulk mode. em28xx 1-3:1.0: We currently don't support analog TV or stream capture on dual tuners. tveeprom: has no radio, has IR receiver, has no IR transmitter tveeprom: audio processor is None (idx 0) tveeprom: TV standards PAL(B/G) NTSC(M) PAL(I) SECAM(L/L') PAL(D/D1/K) ATSC/DVB Digital (eeprom 0xfc) tveeprom: tuner model is SiLabs Si2157 (idx 186, type 4) em28xx 1-3:1.0: Identified as Hauppauge WinTV-dualHD DVB (card=99) em28xx 1-3:1.0: microcode start address = 0x0004, boot configuration = 0x01 em28xx 1-3:1.0: DVB interface 0 found: bulk
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |